Activating the arms in Urdhva Hastasana




The work we have to do with the body in Urdhva Hastasana is almost the same as in Tadasana, so the previous posts were I demonstrate exercises and variations for the feet, legs, pelvis and chest we can also apply to this asana. I am going to add other variations to help you understand the work and engagement of the arms and the correct alignment of the spine.
As I previously said, if you have any cardiac condition or high blood pressure don't raise the arms up over than 30 seconds.





  1. Stand up with the feet parallel. Big toes joining together and hells slightly apart. Ground down through the four corners of each foot.
  2. Place a strap around the mid-forearms or on the elbows and tighten it to shoulder width (see how to find the shoulder distance on the post "Learn how to work the arms and chest in Tadasana "), and then place a block between the hands.
  3. Lift the shinbones and the kneecaps up, engaging the quadriceps/thighs muscles and drawing the inner and outer knees (without straining them).
  4. Neutralize your pelvis by pulling the pubic bone toward the navel lengthening the spine and the trunk - this action prevents an excessive curve on the lumbar spine and also keeps the lower rib cage in.
  5. Press on the block and on inhale lift the arms up.
  6. Make sure your lower ribs are not splaying out. Keep your gaze at the horizon, your chin level, and your throat soft and open.

The strap helps to straighten the elbows.
The combination of the block with the strap helps to keep the arms in place, to stabilize and also to strengthen them.










You can do the same exercise without the belt, holding simply the block between the hands (on the bases of the palms) and pressing it when you raise the arms up into Urdhva Hastasana.




  1. Stand up with the middle of your back against a protruding edge of a wall, or a narrow side of an open door.
  2. Using the vertical edge as the centerline, place both heels touching the bottom side of the edge or door.
  3. Bend the knees, in order to be more easy for you to place the rest of the body, and place the tailbone and the middle of the occiput against the edge, moving the tailbone down.
  4. Align the spine vertically, vertebra by vertebra along the same vertical line. The lumbar vertebrae should not touch the protruding edge (there should be a healthy lumbar lordosis).
  5. Slowly straighten the knees while moving the front thighs backward.
  6. On inhale, lift the arms up and check their position relative to the walls behind you.
The wall edge allow you to check if the spine is straight, not going to the right or to the left or tilting in or out, and also to see if the pelvis, and rib cage are in place.




Other Variations



Comments

Popular posts from this blog

Ardha Uttanasana (Standing Half Forward Bend Pose)

Yoga Props